surge protection box,lightning protection box,surge protective box,lightning protective box,surge arrester box,ac surge protection box

Surge Protection Box

Home > Surge Protection Box

Intelligent lightning protection box
Intelligent lightning protection box

Intelligent lightning protection box

Item No.: DXH06-110ZJ/100
DXH06-110ZJ/100 intelligent lightning protection box, used for lightning and overvoltage protection of the single-phase 110V AC power, should be installed in the lightning protection area 1 (LPZ1) and lightning protection zone at the interface of 2 (LPZ2)
INQUIRY
Description
1  Functions

DXH06-110ZJ/100 intelligent lightning protection box, used for lightning and overvoltage protection of the single-phase 110V AC power, should be installed in the lightning protection area 1 (LPZ1) and lightning protection zone at the interface of 2 (LPZ2). Can be installed into the line in the end of the vehicle power supply.

  2  Features

Features of DXH06-110ZJ/100 intelligent lightning protection box are:
  • The large flow capacity, appropriate action voltage protection circuit,sound
  • The built-in over temperature over-current protection, continued flow, highreliability and safety
  • The integral structure, simple installation, convenient maintenance
  • - with intelligent status indication and lightning counting function
Model DXH06-110ZJ/100
Protected Mode L-N、Ｌ-PE 、N-PE
Maximum continuous operating voltage Uc 175Vac
Nominal discharge current In (8/20μs) 40KA
Maximum discharge current Imax (8/20μs) 100KA
Protection level  Up@20kA 1200V
Nominal voltage 110/120Vac,50/60Hz
Installation location Indoor
Installation Wall-mounted pitch 238mm × 140mm, mounting hole 5mm
Access wire section 4～35mm2
Bare wire connection length 12.5mm
Installation wiring torque 4Nm
Enclosure protection degree IP20
Lightning Count 3-digit display
Fault indication Intelligent failure alarm
Operation temperature -40℃～+70℃
Relative humidity ≤95％（25℃）
Altitude ≤3000m
Dimensions 258mm×170mm×90mm
Test standards IEC 61643-1:2005，UL1449-2009

4  Dimensions

The products use 35mm standard rail for installation and have unified structures, as illustrated below.

Figure 6-1 DXH06-110ZJ / 100 Smart Lightning Box Dimensions (Unit: mm)

5  Installation & Maintenance Precautions
1. It is recommended that the wire connections of DXH06-110ZJ / 100 for AC power supply use ‘V’ shape wiring method shown in Figure 8-1. When limited by practical condition and it is difficult to adopt ‘V’ shape wiring, you can also use routine direct- parallel- connection method shown in Figure 8-2.. The connection wire should be as short as possible (shorter than 0.5m) when using direct- parallel- connection method to achieve better protective performances.
2. The connection wires should be multi- core copper ones with cross- sectional area larger than 10mm2 (AWG6).
3. The power supply should be cut off when installing SPDs. Live installation is prohibited. All the wires must be desirable.
4. SPD no special maintenance, just regularly check whether its built-breaker tripped, status indication is normal.
5. If any vertical status lights are off, you can determine the mine has expired, the need for timely replacement.
Derain
Ms.Derain
Elise
Ms.Elise
TOP
google-site-verification: googled0561bc69b0d47a1.html